Yes, we coat garage floors in Sturgeon Bay with a polyurea flake system, the upgrade most people mean when they ask for an epoxy floor. The concrete is diamond ground and repaired, then gets a polyurea base coat, a full broadcast of flake and a clear, UV-stable polyaspartic topcoat. It's $6–$9 per square foot installed, so a 24 × 24 two-car garage runs $3,456–$5,184. Most one- and two-car garages are done in a day, and you can park after 24 to 48 hours.
- Prep
- Diamond grind, CSP 2–3
- Install
- Usually 1 day
- Park on it
- 24–48 hours
- Price
- $6–$9 per sq ft
Garage floors in Sturgeon Bay
Priced from photos and the floor's size
Send photos of the floor and its size, and the price comes back by text or email within 24 hours. Floors are $6–$9 per square foot installed with a $2,000 minimum, so a 24 × 24 two-car garage runs $3,456–$5,184. Heavy crack repair or grinding off an old coating adds to it.
Flake samples at your place
Colors on a screen never match a floor, so we bring real flake samples to your garage or shop. Look at them in your own light, since the same blend can read darker in a dim shop than in a bright garage.
A settled apron gets lifted first
If the apron or a section of the garage floor has sunk, it's lifted with foam and its joints are sealed before the floor is coated. Send photos of both and we'll price them together, and this far out it makes sense to do them on the same trip.
Looking for an epoxy garage floor in Sturgeon Bay?
Most people start by searching for epoxy, and the instinct is right: a resin floor beats bare concrete in a Wisconsin garage. Epoxy is the older chemistry. We install a polyurea base coat with a polyaspartic topcoat, which cures in about a day instead of up to a week, stays clear in sunlight instead of yellowing, and holds up better to hot tires and cold. Epoxy vs. polyaspartic, compared →
What we coat in Sturgeon Bay
Floors are $6–$9 per square foot installed with a $2,000 minimum ($7–$10 for patios and porches), with extra for heavy crack repair or grinding off an old coating. Garage floor coating cost →
Where we coat floors in Sturgeon Bay
Garage floor coating questions
How do I get a floor coating price in Sturgeon Bay?
Send photos of the floor and its size by text or email, with your address. The price comes back within 24 hours. Sturgeon Bay is about 35 miles from our Suamico shop in a straight line, so the date is confirmed once you approve the price.
Is the floor you install in Sturgeon Bay epoxy?
No. It's a polyurea base coat, a full broadcast of flake and a polyaspartic topcoat. Epoxy is the older chemistry: it yellows in sunlight and can take up to a week before you can park. More in epoxy vs. polyaspartic.
Do you coat shop floors in Sturgeon Bay, or only garages?
Both. Shop floors get the same grind, base coat, flake and topcoat as a garage. Rubber tires are fine on a coated floor; steel tracks, chains and dragged buckets can gouge any coating, so tell us what drives in there. More on shop and pole barn floors.
We lift driveways, aprons, walks, patios and steps with foam, and a settled apron gets lifted before the floor is coated.
Concrete leveling in Sturgeon Bay →Garage floor coatings nearby (Door County & Northeast): Luxemburg · Kewaunee · Algoma · Shawano · Oconto · Oconto Falls · Abrams
Farther out: Green Bay · De Pere · Suamico · Howard · Ashwaubenon · Allouez · Bellevue · Ledgeview · Hobart · Pulaski · Appleton · Kaukauna · Little Chute · Kimberly · Neenah · Menasha · Freedom · Wrightstown
Get your Sturgeon Bay floor price from photos
Send a photo of the floor and its size. You'll get a firm price by text or email within 24 hours.

