Yes, we coat garage floors in Green Bay with a polyurea flake system, the upgrade most people mean when they ask for an epoxy floor. The concrete is diamond ground and repaired, then gets a polyurea base coat, a full broadcast of flake and a clear, UV-stable polyaspartic topcoat. It's $6–$9 per square foot installed, so a 24 × 24 two-car garage runs $3,456–$5,184. Most one- and two-car garages are done in a day, and you can park after 24 to 48 hours.
- Prep
- Diamond grind, CSP 2–3
- Install
- Usually 1 day
- Park on it
- 24–48 hours
- Price
- $6–$9 per sq ft
Garage floors in Green Bay
Older floors, old coatings
In Green Bay's older neighborhoods a garage floor can be decades old, with oil stains, salt scaling, cracks and sometimes a coat of paint or roll-on epoxy that's starting to peel. All of it gets diamond ground off and the cracks are filled before anything new goes down, because a coating is only as strong as what's under it.
Salt brine all winter
Green Bay streets are salted from the first snow to spring, and the brine rides into the garage on your tires. On bare concrete it soaks in and scales the surface. On a coated floor it sits on top, and a squeegee pushes it out the door.
Detached garages and cold weather
Plenty of Green Bay homes have a detached garage. Coatings have minimum air and slab temperatures, so a cold detached garage is usually coated spring through fall, while an attached garage can often be done into late fall.
Looking for an epoxy garage floor in Green Bay?
Most people start by searching for epoxy, and the instinct is right: a resin floor beats bare concrete in a Wisconsin garage. Epoxy is the older chemistry. We install a polyurea base coat with a polyaspartic topcoat, which cures in about a day instead of up to a week, stays clear in sunlight instead of yellowing, and holds up better to hot tires and cold. Epoxy vs. polyaspartic, compared →
What we coat in Green Bay
Floors are $6–$9 per square foot installed with a $2,000 minimum ($7–$10 for patios and porches), with extra for heavy crack repair or grinding off an old coating. Garage floor coating cost →
Where we coat floors in Green Bay
Garage floor coating questions
Do you install epoxy garage floors in Green Bay?
We install polyurea flake floors with a polyaspartic topcoat, which is what most people mean when they ask for an epoxy garage floor: hard, glossy and flaked. It cures faster, doesn't yellow in sunlight and handles hot tires and January cold better than an epoxy-only floor. Epoxy vs. polyaspartic has the full comparison.
My Green Bay garage floor is stained and already painted. Can it still be coated?
Yes. Paint, old epoxy and anything peeling is ground off, oil spots are cleaned out, and cracks are filled. Then the floor gets the same base coat, flake and topcoat as a bare slab.
How long until I can park in my garage again?
Most one- and two-car garages are coated in a day. You can walk on it within a few hours and park after about 24 to 48 hours, depending on temperature. We give you the exact times for your floor before we start.
We lift driveways, aprons, walks, patios and steps with foam, and a settled apron gets lifted before the floor is coated.
Concrete leveling in Green Bay →Garage floor coatings nearby (Greater Green Bay): De Pere · Suamico · Howard · Ashwaubenon · Allouez · Bellevue · Ledgeview · Hobart · Pulaski · Wrightstown
Farther out: Abrams · Oconto · Appleton · Kaukauna · Little Chute · Kimberly · Neenah · Menasha · Freedom · Sturgeon Bay · Luxemburg · Kewaunee · Algoma · Shawano · Oconto Falls
Get your Green Bay floor price from photos
Send a photo of the floor and its size. You'll get a firm price by text or email within 24 hours.

